[ Post a Response | The Chevette Forum ]

[ Create Your Own Free Message Board! ]

If you have lost your password, please send an E-Mail to darryl_lowes@hotmail.com to have your password replaced!

Re: Engine rebuild

Posted by FieldsPerformance on 11/19/2007, 2:49 am, in reply to "Engine rebuild"
User logged in as: Stephen
24.159.28.201

AutoZone, Advance Auto Parts, or NAPA should carry all the parts you need! I highly recommend Felpro gaskets, either Sealed Power or Federal Mogul pistons, Hastings or Total Seal (if you can afford them) rings, and Clevite 77 bearings. Install a new Melling (M92) oil pump. If you have machine work done, make sure they set all clearances to the stock measurements. Especially on the valve stem height (.710"). This is CRITICAL! Good luck on the build! Stephen Fields





---

Message Thread: Engine rebuild - Jody 11/19/2007, 12:25 am Re: Engine rebuild - Rick Drake 11/22/2007, 10:31 pm Re: Engine rebuild - FieldsPerformance 11/19/2007, 2:49 am Re: Engine rebuild - Jody 11/19/2007, 9:51 am Re: Engine rebuild - Ra 11/19/2007, 10:53 am Re: Engine rebuild - FieldsPerformance 11/19/2007, 11:31 am Re: Engine rebuild - Jody 11/20/2007, 10:28 am

---

Post a Response

If you have lost your password, please send an E-Mail to darryl_lowes@hotmail.com to have your password replaced!