Holley Dominator carb next to a "racing" Chevette carburetor !
DOMINATION !!
Ok, so you're a little unhappy with your stock Chevette carb. The ¼ mile times aren't low enough to suit you, you can't quite wrap the speedo needle around twice, the new "buzz bomb" "Fast and Furious" imports are giving you fits, and you just can't seem to make the outtake's of "When Police Attack " TV shows.
What do you do ?
Simple. You bolt on a DOMINATOR ! As seen in the photos below, the Holley© Dominator® is quite capable of supplying enough air to feed your voracious little Chevette engine to it's little hearts content ! Just find a Holley 1050 or 1150 CFM Dominator, and head on over to your local hardware store for some 8" drain pipe and caulking compound.
Cut the 8" drain pipe down to a
reasonable height ( about 6" high should do, you'll have to cut a hole in the hood or
remove it anyway ), and glue it to your Chevette intake with the caulking compound. On the
other end of the 8" drain pipe glue the Holley Dominator, fix up some fuel
lines, and fabricate up some linkage.
( Choke ? Don't make me laugh...... )
Holley Dominator carb next to a "racing" Chevette carburetor !
I can supply Chevette Dominator Super Mega Ultra Street Sweeper©®™ Kits for about $17,000 each.
( Push vehicles required to get the vehicle up to about 217MPH before the Chevette engine will start and begin to use the Dominator carburetor efficiently sold separately. )